2014 Charger back glass

[ready2work]

I just finished a Charger back glass because the customer wanted a darker film on the back doors and I saw a few imperfections on the back glass so I decided to redo it.  After molding it on outside it was flawless when I installed it a lot of little creases appeared at the top in the teflon lined area.  I used suntek 5%.  Did I miss something? I've done tons of these and never had this issue before.

[Slick]

??? 13 years experience?

[no ma'am]

Peal it back and stick the top again w less soap. Then heat and touch up

[jh812]

Man, f**k a charger

[no ma'am]

also

[highplains]

[Slick]

I agree....Chargers suck...but with 13 years experience...eh.....maybe I'm just gettin old and cranky....

[ready2work]

Yea done a bunch of them never had an issue.  This one was the first I had seen do this.

[F150Chic]

I don't have the most experience, but I turn the rear defrost on while cleaning and installing. Seems to work much better. Use steel wool to smooth the lines.

[ready2work]

Never tried that but wouldnt the steel wool take the defrost lines off? Or maybe take some of it off and cause issues with the defrost lines?