Jump to content

slangin papas on a boat


Recommended Posts

bit of hard work. we coudnt precut from the outside cause it was raining and very windy. we did this a local marina 5 mintues from our shop. all winders where safety double pane. except the corner glass on both sides were double plastic, didnt even try tinting, upon trying to precut the olfa got stuck on the edge. clearly plastic shizz.. customer was good about it and left it like that. sweet boat. first time we actually had to out to the boat and do the job :gasp

35 true grey smoke

boatpic11.jpg

boatpic13.jpg

boatpic10.jpg

boatpic9.jpg

boatpic8.jpg

boatpic7.jpg

boatpic5.jpg

boatpic.jpg

Link to comment
Share on other sites

HAHAH those wrap around winds are a BITCH :beer I did one last summer and it tore my azz up :gasp never again.

I bet it was if you couldn't precut it from the outside. These boats usually aren't too bad to tint though, can make some good money on them. We did this boat a couple months back:

Picture019.jpg

Link to comment
Share on other sites

Archived

This topic is now archived and is closed to further replies.

×
×
  • Create New...